|
Abstract:
Attention
the board is installed with the parts towards A1200 mainboard and
direction to the keyboard which is fully different to Twister1200
rev.1 or Melody1200!
The new Twister 1200 Mk II is a redesigned cost reduced
version of the original Twister project, which, thanks to a quite
different software and hardware approach
when compared to similar products, has received already much consent
within the community of ultra fast serial connection surfers. Redesign,
production and distribution is done by DCE.
Katodev still does support, though. Here
just a few of the features of the Twister 1200 Mk II:
Features:
- New design for an easier fit in different hardware configurations.
- Stong number of bitrates supported
- Very fast serial interface for Amiga 1200, 460,800 bps (up to
691,200).
- Perfectly compatible with the Z-IV, new bus board for
A1200
- Can be used together with the Melody 1200, the audio
card
- Although recommended, it doesn't require a Tower case to work.
- To the best of our knowledge, the Twister 1200 Mk II is the
only serial card for Amiga 1200 supporting FIFO based automatic
flow control. (The receiver is able to hold the transfer if the
sender is too fast. Unlike the standard Amiga serial port or other
similar products, the well known "hardware buffer overrun"
message is obsolete.
Screenshots:
This schnapshot shows Olsen's
TERM using twister.device at bitrate of 691.200 BPS (that's out
of chip spec test but shows typical feature) and a throughput of
28.000 Characters per second. That's all the 68030 we used for the
test was able to move. Although there is a powerfull transmission
running there are no overflows and systemload is low compared to
other interfaces.
Status:
|